Malibu V6-3.1L VIN J (2002)
Body Control Module: Customer Interest
Instrument Panel - Rattle/Itching Noise
File In Section: 08 - Body and Accessories
Bulletin No.: 02-08-49-002
Date: May, 2002
TECHNICAL
Subject:
Dash Rattle/Itching Noise From Instrument Panel/Glove Box Area While Driving (Reposition Body Control Module (BCM) Bracket and Insulate
Blower Motor Bolt Washer)
Models:
2002 Chevrolet Malibu
2002 Oldsmobile Alero
2002 Pontiac Grand Am
Built Prior to VIN Breakpoints 2C535843 or 2M137264
Condition
Some customers may comment on a dash rattle/itching type noise from the instrument panel/glove box area while driving.
Cause
This condition may be caused by the BCM mounting bracket contacting the bolt head washer of the blower motor mounting bolts.
Correction
To correct this condition, follow the service procedure below:
1.
Remove the screws retaining the instrument panel right side closeout/insulator panel.
2.
Remove the instrument panel closeout/insulator panel.
3.
Slide the BCM out of the BCM bracket.
4.
Inspect for a contact point between the BCM bracket (2) and the blower motor screw head washer (1).
5.
Reposition the BCM bracket (2) approximately 5 mm (0.2 in) down by pulling down on the BCM bracket (2) near the contact point.
6.
Install one Electrical Moisture Sealant Patch, 3M(R) P/N 054007-06149 or equivalent, on the blower motor between the BCM bracket (2) and the
blower motor screw head washer (1).
7.
Reinstall the BCM into the BCM bracket (2).
8.
Install the instrument panel right side closeout/insulator panel.