Malibu V6-3.1L VIN J (2002)
9. Remove the accelerator cable from vehicle noting cable routing.
INSTALLATION PROCEDURE
NOTE: Do not route flexible components (hoses, wires, conduits, etc.) within 50 mm (2 in) of moving parts unless flexible components can be
securely fastened. This is necessary in order to prevent possible interference and damage to the component.
1. Install accelerator cable using the routing noted during removal.
2. Install the snap retainer through the bulkhead.
3. Connect the accelerator cable (5) in the slot in the accelerator pedal lever (1).
4. Seat the snap retainer in the accelerator pedal lever.
