Malibu V6-3.1L VIN J (2002)
1. Place the shift shaft in the N (Neutral) position.
2. Align the flats of the shift shaft to the flats in the park/neutral switch.
Notice: Refer to Fastener Notice in Service Precaution.
3. Install the park/neutral position switch mounting bolts.
-
Tighten
-
Tighten the bolts to 24 Nm (18 ft. lbs.).
4. Connect the switch electrical connector.
Important: Ensure that the engine will only start in P (Park) or N (Neutral). Readjust the switch if the engine will start in any other position.