Malibu V6-3.1L VIN J (2002)
Stabilizer Bushing: Customer Interest
Suspension - Front/Rear Squawking Noise
File In Section: 03 - Suspension
Bulletin No.: 01-03-08-003A
Date: February, 2002
TECHNICAL
Subject:
Squawk Noise from Front and/or Rear Suspension
(Lubricate Stabilizer Bushings)
Models:
1997-2002 Chevrolet Malibu
1997-1999 Oldsmobile Cutlass
1999-2002 Oldsmobile Alero
1999-2002 Pontiac Grand Am
This is being revised to include additional graphics and torque specifications.
Please discard Corporate Bulletin Number 01-03-08-003 (Suspension).
Condition
Some customers may comment on a squawk noise from the front and/or rear suspension while driving.
Cause
The noise may be due to a slip/stick condition between the front and/or rear stabilizer bushings.
Correction
Follow the service procedure below and lubricate the front and/or rear stabilizer bushings with Special Lubricant High Temperature, P/N 12345879 (in
Canada, use P/N 10953511).
Service Procedure for Front Suspension
1.
Raise and support the vehicle allowing the front suspension to hang free. Refer to Lifting and Jacking the Vehicle (SI2000 Document ID #
632491) in the General Information sub-section of the Service Manual.
2.
Remove the stabilizer shaft links. Refer to Stabilizer Shaft Link Replacement (SI2000 Document ID # 635842) in the Front Suspension
sub-section of the Service Manual.
3.
Support the rear of the crossmember with an adjustable jack stand.
4.
Remove the rear bolts from the crossmember.
5.
Remove the lower control arm rear bolts.
6.
Lower the rear of the crossmember with the adjustable jack stand.
7.
Remove the power steering line bracket from the suspension crossmember on the right side of the vehicle.
