Malibu V6-3.1L VIN J (2002)
*
The stabilizer shaft
Refer to Stabilizer Shaft Replacement.
*
The lower radiator mounting panel
Refer to Radiator Support Replacement in Cooling System.
2. Lower the vehicle on to the frame (3).
3. Install the frame to body bolts (2). Hand tighten the bolts.
4. Install the frame rear bolts (1). Hand tighten the bolts.
5. Install the frame front bolts (4). Hand tighten the bolts.
Notice: Refer to Fastener Notice in Service Precautions.
6. Tighten the bolts in the following order:
1. Tighten the rear bolts (1) to 245 N.m (180 lb ft) plus 180 degrees rotation.
2. Tighten the front bolts (4) to 110 N.m (81 lb ft).
3. Tighten the body bolts (2) to 82 N.m (61 lb ft).
7. Raise the vehicle and support with jack stands. Refer to Vehicle Lifting.
8. Install the brake lines to the retainers on the frame (3).
9. Install the rear transmission mount bracket bolts.
10. Install the front transmission mount bracket bolts.
11. Install the power steering lines to the steering gear.
12. Install the bolt from the steering gear to intermediate shaft.
13. Install the tie rod ends to the steering knuckles.
14. Install the brake modulator assembly to the front suspension crossmember.
15. Install the lower ball joints to the steering knuckles.
16. Connect the ABS sensor to the wheel speed sensor and front suspension crossmember.
17. Install the splash shields.
18. Install the tire and wheel assemblies.
19. Remove the engine support fixture.
20. Bleed the power steering system. Refer to Bleeding the Power Steering System in Power Steering System.
