Malibu V6-3.1L VIN J (2002)
1. Install the range selector cable through the cowl and carpet.
Notice: Refer to Fastener Notice in Service Precaution.
2. Install the range selector cable grommet and the bolts in the cowl.
-
Tighten the grommet bolts to 2 Nm (18 inch lbs.).
3. Install the range selector cable into the bracket.
4. Connect the transaxle range selector cable terminal to the shift lever pin.
5. Push the cable locking clip fully downward.
6. Install the center control.
7. Position the range selector cable to the transaxle cable bracket.
8. Connect the transaxle range selector cable terminal to the transaxle manual shift lever pin.
9. Place the shift lever in NEUTRAL. NEUTRAL can be located by rotating the selector shaft clockwise from PARK through REVERSE to
NEUTRAL.
10. Place the shift control assembly in NEUTRAL.
11. Push on the cable adjuster (4) in order to adjust cable in the cable mounting bracket.
