chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Passenger Assist Handle > < Headliner Replacement (Extended Sedan)|Page 10419
Page 6
background image

Notice:  Refer to Fastener Notice in Service Precautions.

6. Install the rear junction block to the vehicle and secure with the fastener.

Tighten the fastener to 2.5 N.m (22 lb in).

7. Install the rear body trim panel.
8. Install the rear seat bolster assembly.
9. Place the driver seat in an upright position.

10. Install the front passenger seat.
11. Install the rear fasteners to the headliner.
12. Connect the sunroof motor electrical connector.
13. Install the assist handles.
14. On the extended sedan, Install the lower rear quarter trim panels. Refer to Trim Panel Replacement - Rear Quarter Lower (Extended Sedan).
15. Install the upper panels to the rear quarter trim.
16. Install the garnish moldings to the upper center pillar.
17. Install the sunshade supports.
18. Install the sunshades.
19. Install the windshield garnish moldings.
20. Enable the roof rail SIR system. Refer to SIR Disabling and Enabling Zone 8 in Restraint Systems.

Passenger Assist Handle > < Headliner Replacement (Extended Sedan)|Page 10419