Malibu V6-3.5L VIN 8 (2004)
8. Remove the seat belt anchor from the seat frame.
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.
1. Install the seat belt anchor to the seat frame.
Tighten
Tighten the anchor to 32 N.m (24 lb ft).
2. Install the front seat mounting fasteners.
Tighten
Tighten the fasteners to 35 N.m (26 lb ft).
IMPORTANT: Route the heat switch wire harness through the V-retainers in the trim panel.
