chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Recall - Unwanted ABS Activation/ABS Warning Lamp ON|Page 5294 > < Brake Pedal Position Sensor <--> [Braking Sensor/Switch]|Service and Repair|Page 5285
Page 1
background image

Technical Service Bulletin # 04030A

Date: 041210

Recall - Unwanted ABS Activation/ABS Warning Lamp ON

Product Safety - Unwanted ABS Activation # 04030A - (Dec 10, 2004)

Models:
2004 Chevrolet Malibu, Malibu Maxx

Equipped with Anti-Lock Brakes (ABS)

THIS BULLETIN IS BEING REVISED TO ADVISE DEALERS TO ORDER PARTS, IF NECESSARY, FROM GMSPO RATHER THAN THE
PQC.

THIS BULLETIN CANCELS AND REPLACES BULLETIN 04030, ISSUED JUNE 2004. PLEASE DISCARD ALL COPIES OF BULLETIN 04030.

Condition

General Motors has decided that a defect which relates to motor vehicle safety exists in certain 2004 Chevrolet Malibu and Malibu Maxx vehicles
equipped with anti-lock brake system (ABS). The ABS controller may calculate a higher than actual vehicle speed if there is an erratic rear-wheel speed
sensor signal. This can cause ABS activation where it is not needed or cause needed ABS activation to be extended during braking as the vehicle speed
drops to about 5 km/h (3 mph). A four wheel ABS activation could occur for a maximum of 1.25 seconds on a level surface or for up to 2.5 seconds if
the vehicle is on a grade, resulting in increased stopping distances of up to 3.4 m (11.4 ft). If this condition occurs where stopping distance is limited, a
crash could occur.

Some customers may experience illumination of the ABS warning lamp on the instrument panel. That can occur when the system detects the erratic
speed signals and it means that the ABS is disabled. The brake system will perform normally in non-ABS mode until the vehicle is restarted and the ABS
lamp is off.

Correction

Dealers are to reprogram the ABS controller.

Vehicles Involved

Involved are certain 2004 Chevrolet Malibu and Malibu Maxx vehicles equipped with ABS and built within the VIN breakpoints shown.

Important:

Dealers should confirm vehicle eligibility through GMVIS (GM Vehicle Inquiry System) before beginning recall repairs. [Not all vehicles within the
above breakpoints may be involved.]

For US

For dealers with involved vehicles, a Campaign Initiation Detail Report containing the complete Vehicle Identification Number, customer name and
address data has been prepared and will be loaded to the GM DealerWorld, Recall Information website. Dealers that have no involved vehicles currently
assigned will not have a report available in GM DealerWorld.

For Canada

For dealers with involved vehicles, a Campaign Initiation Detail Report containing the complete Vehicle Identification Number, customer name and
address data has been prepared, and is being furnished to involved dealers. Dealers that have no involved vehicles currently assigned, will not receive a
report with the recall bulletin.

The Campaign Initiation Detail Report may contain customer names and addresses obtained from Motor Vehicle Registration Records. The use of such
motor vehicle registration data for any other purpose is a violation of law in several states/provinces/countries. Accordingly, you are urged to limit the
use of this report to the follow-up necessary to complete this program.

Recall - Unwanted ABS Activation/ABS Warning Lamp ON|Page 5294 > < Brake Pedal Position Sensor <--> [Braking Sensor/Switch]|Service and Repair|Page 5285