Malibu V6-3.5L VIN 8 (2004)
4. Install the 2 brake pedal assembly to cowl mounting nuts.
Tighten
Tighten the nuts to 15 Nm (11 lb ft).
5. Install the booster pushrod retaining clip (1), the washers (2), and the booster pushrod (3) to the adjustable pedal pivot pin (4).
6. Install the steering column assembly to the vehicle.
7. Install the NEW cable.
8. Install the electrical connector to the brake pedal adjustment position sensor.
9. Install the electrical connector to the brake apply sensor.
10. Install the closeout panel.
11. Install the knee bolster.
12. Calibrate the brake pedal position sensor.
