Malibu V6-3.5L VIN 8 (2004)
1. Ensure the brake pad hardware mating surfaces (1) are clean.
2. Install the brake pad retainers (2) to the brake caliper bracket.
Important: The wear sensor equipped disc brake pad must be mounted inboard of the rotor with the leading edge of the sensor facing the brake
rotor during forward wheel rotation, or at the top of the pad when installed in vehicle position.
3. Install the brake pads (2) to the caliper bracket.
4. Remove the support (1), and rotate the brake caliper into position over the disc brake pads and to the caliper mounting bracket.
Notice: Refer to Fastener Notice in Service Precautions.
5. Install the lower brake caliper guide pin bolt (1).
^
Tighten the bolt to 35 Nm (26 ft. lbs.).
