Malibu V6-3.5L VIN 8 (2004)
Notice: Refer to Fastener Notice in Service Precautions.
Notice: This is a self-retaining fastener joint that does not require thread locking compounds. Do not attempt to clean the threads with a standard tap.
If a standard tap is used, damage to the joint threads will occur.
1. Install the brake caliper mounting bracket to the steering knuckle.
2. Install the brake caliper mounting bracket bolts (1).
^
Tighten the bolts to 115 Nm (85 ft. lbs.).
3. Apply a very thin coating of high temperature silicone brake lubricant to the pad hardware mating surfaces (1) of the caliper bracket only.
4. Clean the brake pad mating surfaces of the brake pad retainers (2).
5. Install the brake pad retainers (2) to the brake caliper bracket.
Important: The wear sensor equipped disc brake pad must be mounted inboard of the rotor with the leading edge of the sensor facing the brake
rotor during forward wheel rotation, or at the top of the pad when installed in vehicle position.
6. Install the brake pads (2) to the brake caliper bracket.
7. Remove the support (1) and reposition the brake caliper over the brake pads and to the mounting bracket.
Rear
Brake Caliper Bracket Replacement- Rear
Removal Procedure
