Malibu V6-3.5L VIN 8 (2004)
Important: Apply sealant GM P/N 12378521 (Canadian P/N 88901 148), or equivalent' at the cylinder head to lower intake manifold joint.
1. Apply sealant at the cylinder head to lower intake manifold joint at the rear of the lower intake manifold (1).
2. Install the right valve rocker arm cover.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the valve rocker arm cover bolts.
^
Tighten the bolts to 10 Nm (89 inch lbs.).
4. Install the vacuum hose to the grommet in the right valve rocker arm cover.
5. Install the ignition coil bracket studs.
6. Install the ignition coil bracket with coils.
7. Install the EVAP purge valve.
8. Connect the vacuum hoses to the EVAP purge valve.
9. Install the right spark plug wires.
10. Install the generator bracket.
