Malibu V6-3.5L VIN 8 (2004)
2. Connect both front end sensors connector to the front end sensor (1).
3. Connect both CPA's to each front end sensor connector.
4. Install the AIR BAG (IGN) and AIR BAG (BATT) fuses into the BCM fuse center (1).
5. Use caution while reaching in and turn the ignition switch to the ON position.
The AIR BAG indicator will flash then turn OFF.
6. Perform the Diagnostic System Check - Vehicle if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System
Check - Vehicle in Vehicle DTC Information.
