Malibu V6-3.5L VIN 8 (2004)
19.
Reinstall the metal retaining clip.
Important:
All shifter cable and park lock cable clips are one time usage only. Any service repair requiring cables to be disconnected from the transaxle
control cable bracket or shifter assembly will require a cable clip replacement.
20.
Attach the shift cable to the transmission shift lever.
21.
Install the shift cable to the control assembly both at the base and to the pin.
22.
Adjust the shift cable at the transmission, if necessary (with both shifter and transmission lever in PARK position, release and reset the
"C/Locking" clip adjuster).
23.
Reinstall the coolant reservoir/surge tank.
24.
Reinstall the two bolts retaining the dash center support to the floor pan.
Tighten
Tighten the bolts to 10 N.m (89 lb in).
25.
Reposition the carpet and the insulator on the bulk head.
26.
Reinstall the driver's side under dash close out panel.
27.
Reinstall the center console.
28.
Road test the vehicle and confirm complaint noise is no longer present.
Parts Information
Parts are currently available from GMSPO.
Warranty Information
For vehicles repaired under warranty, use the table shown.
Disclaimer
