Malibu V6-3.5L VIN 8 (2004)
1. Install the bulbs to the tail lamp, stop lamp, and/or backup lamp sockets.
2. Install the tail lamp, stop lamp, and/or backup lamp sockets to the tail lamp. Rotate the sockets clockwise until fully seated.
3. Connect the electrical connector to the tail lamp wiring harness.
4. Position the tail lamp to the quarter panel. Ensure that the 2 locking pins are seated.
NOTE: Refer to Fastener Notice in Service Precautions.
5. Install the tail lamp screws to the tail lamp.
Tighten
Tighten the tail lamp screw to 2 N.m (18 lb in).
6. From the inside of the rear compartment, install the wing nut to the tail lamp.
7. Install the trim panel.
8. Close the rear compartment lid.
