Malibu V6-3.5L VIN 8 (2004)
2.
Compare the measurement to the J specification. Refer to Trim Height Specifications.
3.
If the measurement is outside of the specified range, replace the front springs.
4.
Using your hands, lift the rear bumper approximately 38 mm (1.59 in).
5.
Gently remove your hands and allow the vehicle to lower.
6.
Using your hands, jounce the rear of the vehicle downward approximately 38 mm (1.59 in).
7.
Gently remove your hands and allow the vehicle to rise.
8.
Measuring the K dimension for the left and right side of the vehicle inboard of the pinch-weld flange at 560 mm (22 in) from the centerline of the
rear wheel.
9.
Compare the measurement to the K specification.
10.
If the measurement is outside of the specified range, replace the rear springs.
The Z height dimension measurement determines the proper ride height for the front end of the vehicle. There is no adjustment procedure. Repair
may require replacement of suspension components.
Use the following procedure to check the Z height dimension:
1.
Using your hands, lift the front bumper approximately 38 mm (1.59 in).
2.
Gently remove your hands and allow the vehicle to settle
3.
Repeat this operation a total of 3 times.
4.
Measure at the bottom edge of the support flange and subtract the measurement from the lowest point of the ball stud. This will give you your Z
height dimension.
5.
Using your hands, jounce the front of the vehicle downward approximately 38 mm (1.59 in).
6.
Gently remove your hands and allow the vehicle to settle
7.
Repeat the jouncing operation 2 more times.
8.
Measure the Z height dimension.
9.
The true Z height dimension number is the average of the high and the low measurements.
The D height dimension measurement determines the proper rear end ride height. There is no adjustment procedure. Repair may require
replacement of suspension components.
