Malibu V6-3.5L VIN 8 (2004)
9. Remove the hub and bearing assembly from the steering knuckle.
Installation Procedure
1. Install the hub and bearing assembly to the steering knuckle.
Notice: This is a self-retaining fastener joint that does not require thread locking compounds. Do not attempt to clean the threads with a standard
tap. If a standard tap is used, damage to the joint threads will occur.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the 3 hub and bearing assembly bolts.
^
Tighten the hub and bearing assembly bolts to 115 Nm (85 ft. lbs.).
3. Install the wheel speed sensor connector into the bracket until the locking tabs click into place, if equipped with ABS.
4. Connect the electrical connector to the wheel speed sensor, if equipped with ABS.
