Malibu V6-3.5L VIN 8 (2004)
8. Use a flat-bladed tool to remove the locking pins from the body harness connector.
9. Disconnect the body harness connector.
10. Disconnect the remaining wiring harness connectors from the junction block.
INSTALLATION PROCEDURE
1. With the electrical center turned upside down, install the electrical center harness connectors into the electrical center.
2. Install the locking pin to the power supply connector
NOTE: Refer to Fastener Notice in Cautions in Notices.
3. Install the bolts retaining the engine, I/P, and forward lamp wiring harness connectors to the junction block.
