Malibu V6-3.5L VIN 8 (2004)
47. Cut the yellow harness connector out of the vehicle, leaving at least 16 cm (6 in) of wire at the connector.
48. Strip 13 mm (0.5 in) of insulation from each of the connector wire leads.
49. Cut two 6.1 m (20 ft) deployment wires from a 0.8 mm (18 gage) or thicker multi-strand wire. These wires will be used to fabricate the IP module
deployment harness.
50. Strip 13 mm (0.5 in) of insulation from both ends of the wires cut in the previous step.
51. Twist together one end from each of the wires in order to short the wires.
52. Twist together two connector wire leads (the high circuits from both stages of the steering wheel module) to one sets of deployment wires. Refer to
SIR Connector End Views in order to determine the correct circuits.
53. Inspect that the 3 wire connection is secure.
