Malibu V6-3.5L VIN 8 (2004)
Inflatable Restraint Sensing And Diagnostic Module: Service and Repair
INFLATABLE RESTRAINT SENSING AND DIAGNOSTIC MODULE REPLACEMENT
REMOVAL PROCEDURE
CAUTION:
-
Do not strike or jolt the inflatable restraint sensing and diagnostic module (SDM). Before applying power to the SDM, make sure that it is
securely fastened with the arrow facing toward the front of the vehicle. Failure to observe the correct installation procedure could cause
SIR deployment, personal injury, or unnecessary SIR system repairs.
-
If the vehicle interior is exposed to moisture and becomes soaked up to the level of the sensing and diagnostic module (SDM), the SDM
and the SDM harness connector must be replaced. The SDM could be activated when powered, which could cause the airbag deployment
and result in personal injury.
1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 8 in Restraint Systems.
2. Remove the console.
3. Remove the inflatable restraint sensing and diagnostic module nuts.
4. Remove the inflatable restraint sensing and diagnostic module wire harness connector.
5. Remove the inflatable restraint sensing and diagnostic module.
INSTALLATION PROCEDURE
1. Point the arrow on the SDM toward the front of the vehicle.
2. Install the inflatable restraint sensing and diagnostic module.
3. Install the inflatable restraint sensing and diagnostic module wire harness connector.
NOTE: Refer to Fastener Notice in Service Precautions.
4. Install the inflatable restraint sensing and diagnostic module nuts.
