Malibu V6-3.5L VIN 8 (2004)
Manifold Pressure/Vacuum Sensor: Service and Repair
MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR REPLACEMENT
REMOVAL PROCEDURE
1. Disconnect the MAP sensor electrical connector.
2. Remove the MAP sensor attaching screw.
3. Remove the MAP sensor and MAP sensor seal from the upper intake manifold.
INSTALLATION PROCEDURE
1. Install the MAP sensor and MAP sensor seal into the upper intake manifold.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the MAP sensor attaching screw.
Tighten
Tighten the attaching screw to 6.5 N.m (5.7 lb in).
3. Connect the MAP sensor electrical connector.