Malibu V6-3.5L VIN 8 (2004)
5. Remove the transaxle range switch bolts and remove the switch.
Installation Procedure (Old Switch)
1. Make sure the transaxle manual shaft is in the Neutral position.
2. Align the flats on the transaxle shift shaft with the flats on the transaxle range switch and install the switch.
3. Loosely install the transaxle range switch bolts.
4. Insert the J 41545 as shown and rotate the switch until the tool drops onto position.
Notice: Refer to Fastener Notice in Service Precautions.
5. Tighten the transaxle range switch bolts.
Tighten the range switch bolts to 20 Nm (15 ft. lbs.).
6. Remove the alignment tool.
