Malibu V6-3.5L VIN 8 (2004)
5. Remove the lower control arm.
6. Remove the strut to steering knuckle nuts and bolts.
7. Remove the steering knuckle from the vehicle.
Installation Procedure
Notice: Refer to Fastener Notice in Service Precautions.
1. Install the steering knuckle to the strut assembly and if applicable the ABS harness bracket.
^
Tighten the bolts and nuts to 120 Nm (89 ft. lbs.).
2. Guide the axle through the steering knuckle.
3. Install the outer tie rod to the steering knuckle. Tighten
3.1.
Tighten the nut to 20 Nm (15 ft. lbs.).
3.2.
Turn the nut an additional 180 degrees.
