Malibu V6-3.5L VIN 8 (2004)
15.
Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
16.
Enable the SIR system. Refer to SIR Disabling and Enabling
17.
Inspect the steering column components for correct operation.
18.
Reprogram the steering system. Refer to Control Module References.
Tilt Lever Replacement (HPS)
Removal Procedure
1.
Disable the SIR system.
2.
Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
3.
Remove the steering column knee bolster. Refer to Knee Bolster Replacement.
4.
Disconnect the steering column electrical connectors.
5.
Disconnect the vehicle stability enhancement system (VSES) sensor harness connector at the steering column lower bearing. Open the steering
column wire harness retainer clip.
Important:
DO NOT disconnect the adjustable brake pedal cable.
6.
Loosen the lower steering column mounting bolt.
Note:
Once the steering column is lowered, the column is extremely susceptible to damage. Leaning on or pushing down on the column will result in
damage to the intermediate shaft boot seal and could cause the jacket to bend or deform.
7.
Remove the upper steering column mounting bolts (1).
8.
Actuate the tilt lever to full "UNLOCK" position to release the coil spring tension.
