Malibu V6-3.5L VIN 8 (2004)
Steering Gear: Service and Repair
Power Steering Gear
Power Steering Gear Replacement
Removal Procedure
1. Turn the steering wheel to the straight forward position and remove the key from the ignition.
2. Raise and support the vehicle.
3. Remove the front tires and wheels.
4. Remove the intermediate shaft to steering gear pinch bolt. Discard the bolt
Important: Do not rotate the intermediate shaft once separated from the steering gear.
5. Disconnect the intermediate shaft from the steering gear. Note the alignment for installation.
6. Disconnect the outer tie rod end from the steering knuckle.
7. Remove the steering gear to frame bolts.
8. Remove the steering gear through the left side of the vehicle. Rotate the gear 90 degrees in order to clear the rear transmission mount.
9. If replacing the steering gear, remove the outer tie rod ends.
Installation Procedure
