Malibu V6-3.5L VIN 8 (2004)
1. Install the outer tie rod ends to the steering gear.
2. Install the steering gear to the vehicle. Rotate the gear as necessary to clear the rear transmission mount.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the steering gear to frame bolts
^
Tighten the bolts to 70 Nm (52 ft. lbs.) plus an additional 90 degrees.
4. Connect the intermediate steering shaft to the steering gear as noted during removal.
5. Install the new intermediate steering shaft to steering gear pinch bolt.
^
Tighten the bolt to 49 Nm (36 ft. lbs.).
6. Connect the outer tie rod ends to the steering knuckle.
7. Install the front tires and wheels.
9. Check the vehicle for alignment.
