Malibu V6-3.5L VIN 8 (2004)
^
The Driven sprocket thrust washer should be installed on the case instead of the channel plate. Damage to the washer, case or channel plate
may occur if it is not installed correctly.
^
Lubricate the new drive link assembly by pouring ATF on it prior to installation. Failure to pre-lube the chain may damage the assembly.
15.
Install the new 7/8 inch drive link, P/N 24210129, and sprockets, P/N's 24210128 and 24210130.
16.
Install a new channel plate gasket, P/N 24201096.
17.
Carefully align the channel plate on the two dowels and rotate the oil pump shaft to permit installation of the channel plate to the case.
Tighten
Tighten the channel plate bolts and valve body bolts.
18.
Reconnect transaxle wiring harness to the solenoids.
19.
Reconnect the manual shift valve link to the manual valve.
20.
Install the valve control side cover.
21.
Install the side cover bolts.
Note:
Use J 41228 when installing the new axle shaft sleeve seal or fluid leaks will occur.
22.
Install the new output shaft sleeve seal, P/N 24201936, and snap ring (57).
23.
Install the PNP switch.
24.
Install the TCC lock up clutch '0' ring and torque converter.
25.
Transfer the transaxle from the bench fixture to the transmission jack.
26.
Reinstall the transaxle into the vehicle using the appropriate Service Information.
Dealer Action
Please contact all customers that were told they would be called when a repair became available.
Parts Information
Parts are currently available from GMSPO.
Warranty Information
