Malibu V6-3.5L VIN 8 (2004)
3. Install the transaxle oil cooler line assembly to the transaxle.
4. Install the transaxle oil cooler line assembly nut.
Tighten the oil cooler line assembly nut to 7 Nm (62 inch lbs.).
5. Lower the vehicle.
6. Add fluid to the transaxle.
7. Start the engine and check for leaks.
Torque Converter, Turbine Shaft Seal Replacement
Torque Converter, Turbine Shaft Seal Replacement
Removal Procedure
Caution: Refer to Battery Disconnect Caution in Service Precautions.
1. Disconnect the negative battery cable.
2. Remove the transmission assembly from the vehicle.
3. Remove the torque convertor assembly from the transmission.
4. Remove the torque convertor O-ring seal from the end of the turbine shaft. Use a screwdriver.
Installation Procedure
