Malibu V6-3.5L VIN 8 (2004)
2. Use the J 41228 in order to install a new sleeve on the output axle. Install the J 41228 so that the collar is in the snap ring groove.
3. Install the axle shaft retaining clip onto the output axle.
4. Install the drive axle assembly.
5. Lower the vehicle.
6. Inspect the shaft sleeve for leaks.
7. Inspect the transmission oil level.
Stub Axle Shaft Sleeve and Seal Replacement
Stub Axle Shaft Sleeve and Seal Replacement
Tools Required
^
J 38868 Shaft Removal Tool
^
J 6125-1B Slide Hammer
^
J 23129 Universal Seal Remover
^
J 41102 Axle Seal Installer
Removal Procedure
Important: Do not damage the seal bore or the sleeve assembly. Fluid leaks may result.
1. Raise and support the vehicle.
2. Remove the drive axle assembly.