Malibu V6-3.5L VIN 8 (2004)
11. Connect the transaxle wiring harness to the following components:
^
TFP switch assembly
^
Pressure control solenoid (red connector)
Important: The 1-2 shift solenoid wires are red and green. The 2-3 shift solenoid wires are red and yellow.
^
1-2 shift solenoid
^
2-3 shift solenoid
^
TCC solenoid
12. Install the oil pump shaft into the control valve body assembly.
Important: If necessary, rotate the oil pump shaft while installing the oil pump assembly in order to engage the shaft splines to the splines on the oil
pump rotor.
13. Install the oil pump assembly onto the oil pump shaft and the control valve body. Hand start and install the oil pump assembly bolts.
Tighten the oil pump bolts to 12 Nm (9 ft. lbs.).
14. Install the transaxle case side cover.
15. Start the engine, warm up the transaxle, and check for leaks.
16. Inspect for proper fluid level.
