Malibu V6-3.6L (2010)
3. Install the 2 brake pedal assembly to cowl mounting nuts and tighten to 15 Nm (11 lb ft).
4. Connect the brake pedal pushrod retaining clip (1) the wave washers (2) and the brake booster pushrod (3) to the brake pedal pin (4).
5. Install the steering column assembly to the vehicle. Refer to Steering Column Replacement (See: Steering and Suspension/Steering/Steering
Column/Service and Repair/Steering Column Replacement).
6. Connect the electrical connector to the brake apply sensor.
7. Install the left side instrument panel insulator panel. Refer to Instrument Panel Insulator Replacement - Left Side (See: Body and Frame/Interior
Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument Panel Insulator Replacement - Left Side).
8. Install the knee bolster. Refer to Driver Knee Bolster Panel Replacement (See: Restraint Systems/Knee Diverter/Service and Repair).
9. Calibrate the brake pedal position sensor. Refer to Brake Pedal Position Sensor Calibration (See: Accessories and Optional Equipment/Pedal
Positioning System/Pedal Positioning Sensor/Service and Repair/Brake Pedal Position Sensor Calibration).
