Malibu V6-3.6L (2010)
1. Inspect the CMP actuator solenoid valve seal for damage. Replace the seal if necessary.
2. Install the CMP actuator solenoid valve.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
3. Install the CMP actuator solenoid valve bolt and tighten to 10 Nm (89 lb in).
4. Connect the engine wiring harness electrical connector (2) to the bank 2 intake CMP actuator solenoid valve.
5. Install the engine mount snubber bracket. Refer to Engine Mount Snubber Bracket Replacement (See: Drive Belts, Mounts, Brackets and
Accessories/Engine Mount/Service and Repair/Engine Mount Snubber Bracket Replacement).
