Malibu V6-3.6L (2010)
1. Install the wheel bearing/hub assembly to the knuckle.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the 4 wheel bearing/hub assembly nuts.
Tighten the nuts to 63 Nm (47 lb ft).
3. Install the stabilizer link bolt at the knuckle. Refer to Stabilizer Shaft Replacement (See: Steering and Suspension/Suspension/Stabilizer
Bar/Service and Repair/Rear Suspension).
4. Connect the electrical connector to the wheel speed sensor.
5. Install the brake rotor. Refer to Rear Brake Rotor Replacement (See: Brakes and Traction Control/Disc Brake System/Brake Rotor/Disc/Service
and Repair/Removal and Replacement/Rear Brake Rotor Replacement).
6. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Service and Repair).
7. Lower the vehicle.