Malibu V6-3.6L (2010)
1. Install a NEW MAF/IAT sensor seal.
2. Install the MAF/IAT sensor.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
3. Install the MAF/IAT sensor screws and tighten to 4 Nm (35 lb in).
4. Connect the engine wiring harness electrical connector to the MAF/IAT sensor.
5. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement (See: Fuel Delivery and Air Induction/Air Cleaner Housing/Air
Cleaner Fresh Air Duct/Hose/Service and Repair/Air Cleaner Outlet Duct Replacement).
