Malibu V6-3.6L (2010)
7. Inspect the CMP actuator solenoid valve seal and replace as necessary.
Installation Procedure
1. Inspect the CMP actuator solenoid valve seal for damage. Replace the seal if necessary.
2. Install the CMP actuator solenoid valve.
3. Loosely install the CMP actuator solenoid valve bolt.
4. Connect the engine wiring harness electrical connector (7) to the bank 1 intake CMP actuator solenoid valve.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
5. Tighten the CMP actuator solenoid valve bolt to 10 Nm (89 lb in).
6. Position the A/C line and install the push pin retainer.
7. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement (See: Fuel Delivery and Air Induction/Air Cleaner Housing/Service
and Repair).
