Malibu V6-3.6L (2010)
10. Install the right engine frame to body bracket. Refer to Frame Replacement (See: Body and Frame/Frame/Service and Repair).
11. Lower the vehicle.
12. Install the brake pipes to the clips.
13. Install the brake, fuel, and EVAP pipe clips (1, 2) to the studs on the front of dash.
14. Remove the caps from the fuel rail pipe and the EVAP purge solenoid.
15. Connect the EVAP pipe (3) quick connect fitting to the EVAP purge solenoid. Refer to Plastic Collar Quick Connect Fitting Service (See: Fuel
Line Coupler/Service and Repair/Plastic Collar Quick Connect Fitting Service).
16. Connect the fuel feed pipe (1) quick connect fitting to the fuel rail. Refer to Metal Collar Quick Connect Fitting Service (See: Fuel Line
Coupler/Service and Repair/Metal Collar Quick Connect Fitting Service).
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
17. Install the fuel feed pipe clip nut (2) to the intake manifold stud and tighten the nut to 10 Nm (89 lb in).
18. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (See: Fuel Injector/Service and Repair/Fuel Injector Sight
Shield Replacement).
