Malibu V6-3.6L (2010)
Note: After adjusting the switch, verify the engine only starts in Park or Neutral. If the engine starts in any other position, adjust the switch.
8. Connect the transaxle range switch electrical connectors.
9. Install the shift control cable to transaxle range switch lever and verify proper operation.
10. Install the shift control cable to transaxle range switch lever and verify proper operation.
Installation Procedure (New Switch)
1. Make sure the transaxle manual shaft is in the Neutral position.
2. Align the flats on the transaxle shift shaft with the flats on the transaxle range switch and install the switch.
3. Tighten the transaxle range switch bolts to 20 Nm (15 lb ft).
Warning
Hold the transmission range selector lever while removing or installing the lever retaining nut. Failure to hold the lever can cause damage to the
transmission internal park system components which could allow the vehicle to roll when placed in the park position.