Malibu V6-3.9L (2007)
Important: Ensure that the brake and accelerator pedal adjustment position sensor is installed correctly to the bracket. The brake and
accelerator pedal adjustment position sensor has a sensing arm that must be installed over the brake pedal actuation arm to ensure it is
sensing brake pedal position.
1. Install the brake and accelerator pedal adjustment position sensor (2) to the brake pedal bracket. Ensure the brake pedal position sensor tab locks
into the brake pedal bracket and the sensor arm is correctly installed.
Notice: Refer to Fastener Notice.
2. Install the brake pedal adjustment position sensor bolt (1).
Tighten the bolt to 2 N.m (18 lb in).
3. Install the electrical connector to the brake and accelerator pedal adjustment position sensor.
4. Install the steering wheel stub shaft to the steering column.
5. Install the closeout panel.
Brake Pedal Position Sensor Replacement
Brake Pedal Position Sensor Replacement
Removal Procedure
1. Remove the closeout panel.
2. Remove the steering wheel stub shaft bolt and position the steering wheel stub shaft away from the steering column in order to gain access to the
brake pedal adjustment position sensor.
3. Remove the electrical connector from the brake pedal position sensor.