Malibu V6-3.9L (2007)
INSTALLATION PROCEDURE
IMPORTANT:
-
The service part comes as an assembly that includes the plenum lower panel. If the repair does not require the plenum, remove the plenum before
you install the dash panel.
-
If the location of the original plug weld holes can not be determined, space the plug weld holes every 40 mm (1 1/2 in) apart.
1. Drill 8 mm (5/16 in) plug weld holes in the service part as necessary in the corresponding locations noted on the original panel.
2. Prepare all mating surfaces as necessary.
3. Apply 3M(R) Weld-Thru Coating P/N 05916 or equivalent to all mating surfaces.
