Malibu V6-3.9L (2007)
Installation Procedure
1. Position the sunroof motor to the sunroof module.
2. Push the sunroof motor straight upward to engage the drive gear between the cables housed within the sunroof cable drive tubes.
Notice: Refer to Fastener Notice.
3. Install the sunroof actuator screws to the sunroof actuator.
Tighten the screws to 4 N.m (35 lb in).
4. Connect the electrical connector to the sunroof motor.
5. Install the headliner.
6. Initialize/teach the sunroof motor. Refer to Sunroof Motor/Actuator Initialization/Teach Process (Existing Motor) Sunroof Motor/Actuator
Initialization/Teach Process (New Motor). See: Procedures/Sunroof Motor/Actuator Initialization/Teach Process (Existing Motor) See:
Procedures/Sunroof Motor/Actuator Initialization/Teach Process (New Motor)
