Malibu V6-3.9L (2007)
Important: Keep the cutting edge of the tool against the window.
4. Remove the window from the urethane adhesive.
* Leave a base of urethane approximately 2 mm (0.078 in) on the pinch-weld flange.
* The only suitable lubrication is clear water.
* Use J 24402-A, J 39032 or equivalent in order to cut the urethane bead to remove the window.
5. With the aid of an assistant, remove the window from the vehicle.
Installation Procedure
1. Install the roof window into the opening. Refer to Urethane Adhesive Installation of Roof Stationary Windows.
2. Remove the double layer of masking tape from around the perimeter of the painted surfaces and the interior trim.
