Malibu V6-3.9L (2007)
4. Remove the J-strips from the seat frame.
5. Remove the J-strip on the recliner rod.
6. If the vehicle is equipped with a heated seat, disconnect the heated seat wiring connector.
7. Remove the seat cushion cover and pad from the seat frame.
8. Remove the hog rings from the under side of the seat cushion.
9. Pull the cushion cover (1) off of the pad (2).
Installation Procedure
1. Push the cushion cover (1) over the cushion pad (2).
Important: Verify that the listing wire is aligned with the trim cover.