chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Body - Buzz/Rattle/Vibration From R/H Side of Dash|Page 17568 > < Spoilers, Flaps, and Air Dams|Service and Repair|Page 17557
Page 1
background image

Cowl Moulding / Trim: Customer Interest
Body - Buzz/Rattle/Vibration From R/H Side of Dash

Bulletin No.: 07-08-111-001

Date: January 26, 2007

TECHNICAL

Subject:
Vibration/Rattle/Buzz Noise From Right Front Side of Dash at Speeds Above 56 km/h (35 mph) (Install Two-Way Tape)

Models:
2006-2007 Malibu, Malibu Maxx

Condition

Some customers may comment on a vibration/rattle/buzz type noise coming from the right side dash area. The noise will start when the vehicle speeds
reach 56 to 64 km/h (35 to 40 mph) and continue up through highway speeds.

Cause

The noise may be coming from the plastic cowl cover screen vibrating and contacting the windshield on the right side of the windshield between the
wiper post and the right side "A" pillar. The cover may be raised off the windshield slightly and the air flow as the vehicle is traveling is pushing the
cover down, causing the rattle/buzz noise.

Correction

Remove the cowl cover and install a strip of double stick tape to the underside of the cover. Install the tape about 102 mm (4 in) from the wiper post
opening to the end of the cover. The tape should be on the plastic cover, not on the seal. Clean the windshield in this area and reinstall the cover. Press
the cover down where the tape was installed.

Parts Information

Warranty Information 

For vehicles under warranty, use the table.

Body - Buzz/Rattle/Vibration From R/H Side of Dash|Page 17568 > < Spoilers, Flaps, and Air Dams|Service and Repair|Page 17557