Malibu V6-3.9L (2007)
Notice: Refer to Fastener Notice.
4. Install the 2 brake pedal assembly to cowl mounting nuts.
Tighten the nuts to 15 N.m (11 lb ft).
5. Install the electrical connector to the brake apply sensor.
6. Install the closeout panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side.
7. Install the proportioning valve bracket assembly with the brake master cylinder to the vehicle.
Important: Ensure the gasket on the outside barrel of the master cylinder is positioned properly and is free of cuts and tears.
8. Install the master cylinder nuts to the vacuum brake booster.
Tighten the nuts to 25 N.m (18 lb ft).
9. Raise the vehicle.
