Malibu V6-3.9L (2007)
Notice: Do NOT use a power-assisted tool with the special tool in order to remove or install this component. You cannot properly control the
alignment of this component using a power-assisted tool, and this can damage the component.
11. Remove the crankshaft balancer using the J 41816 and EN 46359.
Installation Procedure
1. Apply sealer to the keyway of the crankshaft balancer. Refer to Sealers, Adhesives, and Lubricants for the correct part number.
2. Place the crankshaft balancer into position over the key in the crankshaft.
3. Thread the J 29113 into the crankshaft.
4. Rotate the hex nut on the J 29113 in order to install the crankshaft balancer onto the crankshaft.
5. Remove the J 29113 from the crankshaft.
