Malibu V6-3.9L (2007)
Engine Mount: Adjustments
Engine Mount Position Adjustment
Tools Required
J 23498-A Driveshaft Inclinometer
Important: If for some reason there is pressure or preload against the powertrain, it can be put out of design position and this will put stress on
the flex coupling in the exhaust system when the vehicle is driven and the out of position powertrain may cause the exhaust downpipe to hit the
heat shield in the exhaust tunnel during torque loads.
Important: When lifting the vehicle to perform this procedure, the vehicle MUST be lifted using a frame contact hoist, in order for the wheels
and suspension to hang free.
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Loosen, but DO NOT REMOVE the front transaxle mount through bolt.
