Malibu V6-3.9L (2007)
2. Install the air temperature actuator.
Notice: Refer to Fastener Notice.
3. Tighten the air temperature actuator screws.
Tighten the screws to 1.5 N.m (13 lb in).
4. Install the knee bolster.
5. Install the left closeout panel.
6. Install the fuse labeled HVAC CTRL (BATT).
Mode Actuator Replacement
Mode Actuator Replacement
Removal Procedure
1. Remove the fuse labeled HVAC CTRL (BATT).
2. Completely open instrument panel (I/P) compartment door by pressing both tabs that support the stop bumpers. Refer to Instrument Panel
Compartment Replacement.
3. Remove the mode actuator wire harness connector.