Malibu V6-3.9L (2007)
4. Install the J 44551-5 (3) over the end of the suction hose and the suction screen (2).
Important: Correct placement of the J 44551-5 is critical.
5. Tighten the forcing screw of the J 44551-5.
The suction screen is fully installed when the screen is flush with the end of the suction hose.
6. Remove the J 44551-5 from the suction hose.
7. Replace the seal washers.
8. Install the A/C compressor hose assembly to the A/C compressor.
Notice: Refer to Fastener Notice.
9. Install the A/C compressor hose assembly bolt.
Tighten the bolt to 20 N.m (15 lb ft).
10. Evacuate and recharge the A/C system. Refer to Refrigerant Recovery and Recharging.
11. Leak test the fittings of the component using the J 42220.