Malibu V6-3.9L (2007)
Steering Angle Sensor: Service and Repair
Steering Wheel Position Sensor Centering
Steering Wheel Position Sensor Centering
Removal Procedure
Notice: With wheels of the vehicle facing straight ahead, secure the steering wheel utilizing steering column anti-rotation pin, steering column
lock, or a strap to prevent rotation. Locking of the steering column will prevent damage and a possible malfunction of the SIR system. The steering
wheel must be secured in position before disconnecting the following components:
-
The steering column
-
The intermediate shaft(s)
-
The steering gear
After disconnecting these components, do not rotate the steering wheel or move the front tires and wheels. Failure to follow this procedure may
cause the SIR coil assembly to become un-centered and cause possible damage to the SIR coil. If you think the SIR coil has became un-centered,
refer to your specific SIR coil's centering procedure to re-center SIR Coil.
1. With the wheels of the vehicle in the straight ahead position, secure the steering wheel or the steering column with a steering column anti-rotation
pin, a steering column lock, or a strap, as applicable, in order to prevent rotation.
Important: Identify the type of steering wheel position sensor from the illustrations shown BEFORE removing the sensor from the steering
column. Once you have identified the steering wheel position sensor, follow the instructions listed in the removal procedure.
2. Verify the type of steering wheel position sensor.
3. From the technicians point of view, the FRONT of the sensor (1) connector will be on the right.
Important: If reusing the existing sensor, you do not have to align the sensor before removal. Centering is not required when it is time to
reinstall.
4. Remove the connector from the sensor.
5. Remove the sensor (1) from the adapter and bearing assembly.
6. To install the sensor, proceed to step 1 in the installation section.
